摘要：
●Lumped Capacitor Model ●Lumped RC model ●Distributed RC model ○Pi RC network ○T RC network ●RLC model ●Wire Load ......
⊙﹏⊙
●Lumped Capacitor Model ●Lumped RC model ●Distributed RC model ○Pi RC network ○T RC network ●RLC model ●Wire Load
＂Lumped model DIC: %f＂ % m.dicprint ＂Stimulus model DIC: %f＂ % m_stim.dic输出:根据检验结果可以看出,LL的后验对于WL根
＋▽＋
＂ L u m p e d m o d e l D I C : % f ＂ % m . d i c p r i n t ＂ S t i m u l u s m o d e l D I C : % f ＂ % m _ s t i m . d i c shu chu : gen ju jian yan jie guo ke yi kan chu , L L de hou yan dui yu W L gen . . .
lumped model; isothermal reactions; non-isothermal reactions; kinetics of reactions; Aspen Custom Modeler03Preview← 左右滑动查看
The lumped model was employed to predict the thermal abuse reactions and jet dynamics, while the vented gas flow and combustion
洛沦兹Lumped model 集总模型 M Majority carrier 多数载流子Mask 掩膜板,光刻板Mask level 掩模序号Mask set 掩模组Mass - action
when model conditions were updated. Thedecrease is primarily Lumped modelspecies with the highest MIR values in 1988
＂Lumped model DIC: %f＂ % m.dicprint ＂Stimulus model DIC: %f＂ % m_stim.dic输出:根据检验结果可以看出,LL的后验对于WL根
模型改进 (1)权重法 三种模型只适用于单反应体系,而锂离子电池属于多反应体系.本文将电池中所有反应对热失控行为的贡献量作为权重值模型验证 对18650钴酸锂电池进行验证,得到h=20 W m-2 K-1时,热失控临界环境温度及电池温度:SADT=417K失控临界条件影响因素分析 基于修正模型,本文对对流传热系数、电池尺寸和形状三种因素对失控临界条件进行模拟分析,结果如图3所示
ˋ﹏ˊ
甚至可以结合到DSP一起仿真,这里最关键的是lumped model提取,简化优化模型. 参考文献【1】Radi et al, “Optimal Optical
集总式模型(lumped model)和分布式模型(distributed model).一般说来,系统模型和概念性模型都是集中式模型,而物理模型都
发表评论